From this article, you’ll learn how to measure an input/output performance of a file system on such devices as HDD, SSD, USB Flash Drive, etc.
I’ll show how to test the read/write speed of a disk from the Linux command line using ddcommand.
I’ll also show how to install and use hdparm utility for measuring read speed of a disk on Linux Mint, Ubuntu, Debian, CentOS, RHEL.
To get the accurate read/write speed, you should repeat the below tests several times (usually 3-5) and take the average result.
All of the Dedicated servers and Virtual Server ServerPlus.Pro CO includes the best brand and high-performance hard drives.
dd: TEST Disk WRITE Speed
Run the following command to test the WRITE speed of a disk:
$ sync; dd if=/dev/zero of=tempfile bs=1M count=1024; sync
1024+0 records in
1024+0 records out
1073741824 bytes (1.1 GB) copied, 3.28696 s, 327 MB/s
dd: TEST Disk READ Speed
The file tempfile, that has just been created by the previous command, was cached in a buffer and its read speed is much higher than the real read speed directly from the disk.
To get the real speed, we have to clear the cache.
Run the following command to find out the READ speed from buffer:
$ dd if=tempfile of=/dev/null bs=1M count=1024
1024+0 records in
1024+0 records out
1073741824 bytes (1.1 GB) copied, 0.159273 s, 6.7 GB/s
Clear the cache and accurately measure the real READ speed directly from the disk:
$ sudo /sbin/sysctl -w vm.drop_caches=3
vm.drop_caches = 3
$ dd if=tempfile of=/dev/null bs=1M count=1024
1024+0 records in
1024+0 records out
1073741824 bytes (1.1 GB) copied, 2.27431 s, 472 MB/s
dd: TEST Read/Write Speed of an External Drive
To check the performance of some External HDD, SSD, USB Flash Drive, or any other removable device or remote file-system, simply access the mount point and repeat the above commands.
Or you can replace tempfile with the path to your mount point e.g.:
$ sync; dd if=/dev/zero of=/media/user/MyUSB/tempfile bs=1M count=1024; sync
hdparm: Test HDD, SSD, USB Flash Drive’s Performance
hdparm is a Linux command-line utility that allows us to set and view hardware parameters of hard disk drives.
And it can also be used as a simple benchmarking tool that allows us to quickly find out the READ speed of a disk.
hdparm is available from standard repositories on the most Linux distributions.
Install hdparm depending on your Linux distribution.
All of the Dedicated servers and Virtual Server ServerPlus.Pro includes the best brand and high-performance hard drives.
On Linux Mint, Ubuntu, Debian:
$ sudo apt-get install hdparm
On CentOS, RHEL:
$ sudo yum install hdparm
Run hdparm as follows, to measure the READ speed of a storage drive device /dev/sda:
$ sudo hdparm -Tt /dev/sda /dev/sda: Timing cached reads: 16924 MB in 2.00 seconds = 8469.95 MB/sec Timing buffered disk reads: 1386 MB in 3.00 seconds = 461.50 MB/sec
